How to Build Tesla's Radiant Energy Receiver

Radiant energy receivers with emitters available in nature - the sky

1. Understand how radiant energy capture mechanism works

To build Tesla radiant energy receivers, we need to understand Tesla's patent for radiant energy receivers.
Patent on the receiver of radiation energy from the sky:

Two problems with the collection of radiant energy in nature

In the picture above, there are 2 collectors of radiant energy corresponding to figure 1 and figure 2.

Two problems with the collection of radiant energy in nature:

1. In the first machine, Fig. 1, states that there is a electrostatic difference in the dielectric between the earth and the sky. The energy obtained is not too much. Want more power, it has to be scaled up.
2. In the second machine, Fig. 2, is the development method for the method shown in Fig. 1. Specifically, the stimulation, resonance is based on the dielectric tension in the Ether. On a small scale, but thanks to excitation and resonance, unlimited electrical energy is generated. This is how to generate energy for flying saucers, space travel.

2. Circuit diagram of the radiant energy receiver

If we understand the nature of the way to capture radiant energy in figure 2, then we can do the same as Tesla mentioned, or use electronic circuits to pull unlimited "dielectric energy" - just depend on the device to pull: resonance and excitation or "Tesla's impulse technology"

We can build thousands of electrical circuits to pull radiation energy after we understand the nature. Disclosure of dielectric energy is simple in Tesla's patent (figure 2), but shows that Tesla is a generous man.

We can create a multitude of different circuits to replace the part that does the resonance work.

Here is an electrical circuit that uses capacitors and diodes to pull energy from the sky:

The earth connection used here is a 12 mm copper pipe 3 metres long, driven into the ground and the ground around it saturated with water:


It is a very good electrical circuit for collecting radiant energy. However, it is just a hybrid between the patent in Fig. 1 and Fig. 2. To generate more electricity, it is necessary to design more capacitors and diodes.

The diodes used are germanium 1N34 or 1N34a as germanium diodes drop far less voltage than do silicon diodes and the 1N34 types are low-loss diodes, particularly suited to this application. Ceramic disc types are recommended for the 200 nF capacitors. The prototype build looked like this:


Now, consider this circuit as described, to be one modular building block which can lead to unlimited power from an aerial. I will represent the circuit shown above as a rectangle, showing the above circuit as:
The cable is connected to the aluminium plate using a brass bolt and nuts which the builder thinks may be significant, quite apart from avoiding any galvanitic connection to the circuit. The cable is then run vertically downwards to the circuit. For this arrangement a second earthing point is also used. This is a galvanised iron pipe 3 metres long, driven vertically into the ground which is saturated with water. The second earth is 2 metres away from the first earth.

This arrangement provides serious power, enough to cause injury to, or kill a careless human. With two modules, it will light an LED very brightly, driving it to 2.6 volts. If the LED is removed, then the voltage climbs to about twenty volts and is easily sufficient to charge a 12V battery or battery bank although that takes time. With twenty modules as 12V battery can be charged over night. It is estimated that with two hundred modules, the power would be sufficient to power a household although that has not yet been done. It should be borne in mind that each module is easy and cheap to make, so arranging for a stack of them where additional modules can be added at a later date for more power, is an ideal arrangement. The circuit is like this: